How do I install a wind barrier on a generator?

Position the generator set so that the prevailing wind do not enter into the radiator / exhaust outlet. If this is not possible, install a wind barrier. Distance of the wind barrier from the room should be atleast three times radiator core height.

Who makes wind deflectors?

with the UK's leading Wind Deflector manufacturer. Subscribe to our Newsletter to receive 10% off your first order. Edge Visors Wind Deflectors for all car makes and models from the UK's leading Wind Deflector manufacturer. Offering one of the largest selections of Wind Deflectors, available for over 300 models.

How to install a generator set?

Ensure that the concrete is completely set and hardened before positioning the generator set. It is recommended to have foundation height about 100-150 mm above ground level, it helps to maintain cleanliness of genset. Check the foundation level diagonally as well as across the length for even flatness.

How do you reinforce a generator compartment?

An alternate reinforcement method is to place No. 6 reinforcing bars on 12 inch (300mm) centers hori-zontally. Bars should clear the foundation surface a minimum of 3 inches (75mm). Retain the generator compartment to the concrete slab with masonry bolts.

How do you protect a generator from a shock?

Avoid contact with bare wires, terminals, connections, etc., on the generator as well as the transfer switch, if applicable. Ensure all appro-priate covers, guards and barriers are in place before operating the generator. If work must be done around an operating unit, stand on an insulated, dry surface to reduce shock hazard.

How should a generator room be ventilated?

C.5 Enough opening / shutters should be provided to the D.G. room so that entry and placement of D.G. set is possible easily. Ventilation of the generator room is necessary to remove heat and fumes dissipated by the engine, alternator and its accessories and to provide clean and fresh combustion air.